Confirmation Procedure
- CHECK DTC PRIORITY
If DTC P0128 is displayed with DTC P0300, P0301, P0302, P0303, P0304, P0305 or P0306, first perform the trouble diagnosis for P0300, P0301, P0302, P0303, P0304, P0305 or P0306.
Is applicable DTC detected?
YES>>
Perform diagnosis of applicable. Refer to DTC Index .
NO>>
GO TO 2
.
- PRECONDITIONING-1
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
>>
GO TO 3
.
- PRECONDITIONING-2
With CONSULT
- Turn ignition switch ON.
- Check the following conditions:
Ambient temperature -10°C (14°F) or more A/C switch OFF Blower fan switch OFF - Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
- Check the following conditions:
COOLANT TEMP/S [(-10°C) - (+52°C) (14 - 126°F)]
Is the condition satisfied?
YES>>
GO TO 4
.
NO>>
- Satisfy the condition.
-
GO TO 4
.
- PERFORM DTC CONFIRMATION PROCEDURE-1
With CONSULT
- Start engine.
- Drive the vehicle until the following condition is satisfied.CAUTION:
Always drive vehicle at safe speed.
- STEP 1
Drive the vehicle under the conditions instructed below until the difference between "COOLANT TEMP/S" and "FUEL T/TMP SE" becomes at least 23°C (73°F).
COOLANT TEMP/S 68°C (154°F) or less FUEL T/TMP SE Less than the value calculated by subtracting 28°C (82°F) from "COOLANT TEMP/S".* *: ExampleCOOLANT TEMP/S FUEL T/TMP SE 65°C (149°F) 37°C (99°F) or less 60°C (140°F) 32°C (89°F) or less - STEP 2
Drive the vehicle at 60 km/h (37 MPH) or more with the difference between "COOLANT TEMP/S" and "FUEL T/TMP SE" maintained at 28°C (82°F) or more.
NOTE: Keep the accelerator pedal as steady as possible during cruising. - STEP 3
Drive the vehicle at 60 km/h (37 MPH) or more until "COOLANT TEMP/S" increases by 6°C (43°F).
NOTE: Keep the accelerator pedal as steady as possible during cruising.
- STEP 1
Is the condition satisfied?
YES>>
GO TO 5
.
NO>>
GO TO 2
.
- PERFORM DTC CONFIRMATION PROCEDURE-2
With CONSULT
- Drive the vehicle until the following condition is satisfied.
COOLANT TEMP/S 68°C (154°F) or more CAUTION:Always drive vehicle at safe speed.
- Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>
Refer to DTC Diagnosis Procedure .
NO>>
INSPECTION END
- Drive the vehicle until the following condition is satisfied.