SRS Final Check

DIAGNOSIS MODE 

CONSULT

1. Confirm that zero point reset of OCS is complete.
2. If no DTCs are detected on "Self Diagnostic Result [CURRENT]", repair of SRS is completed. Go to step 3. If any DTCs are detected on "Self Diagnostic Result [CURRENT]", the malfunction has not been repaired completely or another malfunction is being detected. Perform SRS Operation Check again. Refer to SRS Operation Check .
3. Select "ERASE".
   NOTE: Selecting "ERASE" will clear the SRS memory of the malfunction ("Self Diagnostic Result [PAST]"). If "Self Diagnostic Result [PAST]" is not erased, User Mode may show the previous system malfunction even if the malfunction has been repaired completely.
4. Check that no malfunction is detected in "Self Diagnostic Result [PAST]".
5. Exit Diagnosis Mode and disconnect the CONSULT.
6. Perform SRS Operation Check. Refer to SRS Operation Check .