Component Function Check

1. With CONSULT
   1. Turn ignition switch ON.
   2. On CONSULT screen, select "ENGINE">>"Data Monitor">>"BRAKE SW1".
   3. Check "BRAKE SW1" indication under the following conditions.

      Monitor item	Condition		Indication
      BRAKE SW1	Brake pedal	Slightly depressed	OFF
      		Fully released	ON

2. Without CONSULT
   1. Turn ignition switch ON.
   2. Check the voltage between ECM harness connector terminals as per the following.

      ECM			Condition		Voltage (Approx.)
      Connector	+	-
      	Terminal
      E32	192 (Brake pedal position switch signal)	204	Brake pedal	Slightly depressed	0 V
      				Fully released	Battery voltage

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Proceed to Diagnosis Procedure .