Work Procedure: Description
When replacing the ABS actuator and electric unit (control unit), the procedures of BEFORE REPLACEMENT and AFTER REPLACEMENT must be performed.
BEFORE REPLACEMENT
When replacing the ABS actuator and electric unit (control unit), save "Operation log".
AFTER REPLACEMENT
After replacing the ABS actuator and electric unit (control unit), the following items must be performed:
- ABS actuator and electric unit (control unit) programming
- ABS actuator and electric unit (control unit) configuration
- Air bleeding of brake fluid
- Adjust the neutral position of steering angle sensor
- Calibration of the decel G sensor
- Calibration of side G sensor
- Adjustment of rear brake caliper initialization position
- Change of system MODE
- Actual driving 3 km or more
NOTE:
Save the odometer information of combination meter in ABS actuator and electric unit (control unit).