Work Procedure

Perform the LDW/LDP system action test. Refer to Description .

GO TO 2.

1. Start the engine.
2. Check that the BSW system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.

GO TO 3.

1. Enable the setting of the BSW system on the integral switch.
2. Turn warning systems switch ON (warning systems ON indicator is ON).
   NOTE: Blind Spot Intervention system is OFF.
3. Check BSW operation according to the following table.

   Vehicle condition/ Driver's operation			Action
   Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the Blind Spot Warning/Blind Spot Intervention indicator	Display on information display	Buzzer
   Less than approx. 29 km/h (18 MPH)	--	--	OFF	BSW system indicator : White Speaker icon : White Courtesy of NISSAN NORTH AMERICA, INC.	OFF
   Approx. 32 km/h (20 MPH) or more	--	Vehicle is not detected	OFF	BSW system indicator : White Speaker icon : White Courtesy of NISSAN NORTH AMERICA, INC.	OFF
   	OFF	Vehicle is detected	ON	BSW system indicator : White Speaker icon : White Courtesy of NISSAN NORTH AMERICA, INC.	OFF
   	ON (vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink	Yellow (Blink) Courtesy of NISSAN NORTH AMERICA, INC.	Short continuous beeps
   				BSW system indicator : Yellow (Blink) Speaker icon : White Courtesy of NISSAN NORTH AMERICA, INC.
   		Vehicle is detected after turn signal operates	Blink	Yellow (Blink) Courtesy of NISSAN NORTH AMERICA, INC.	OFF
   				BSW system indicator : Yellow (Blink) Speaker icon : White Courtesy of NISSAN NORTH AMERICA, INC.

   NOTE:

   • If vehicle speed exceeds approximately 32 km/h (20 MPH), BSW function operates until the vehicle speed becomes lower than approximately 29 km/h (18 MPH).
   • Time shown in the figure is approximate time.
   • Always Blind Spot Intervention system operates together with BSW system. Whenever Blind Spot Intervention system is turned ON in the integral switch, BSW system will also be turned on even if the BSW system is turned off.

GO TO 4.

1. Start the engine.
2. Check that the Blind Spot Intervention system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.

GO TO 5.

1. Start the engine.
2. After starting the engine wait for 5 seconds or more.
3. Enable the setting of the Blind Spot Intervention system on the integral switch.
4. Press the warning system switch.
5. Check that the Blind Spot Intervention ON indicator on the combination meter illuminates.
6. Check that the Blind Spot Intervention ON indicator turns OFF when the system is turned OFF by pressing the warning system switch.
7. Check that the Blind Spot Intervention ON indicator turns OFF when the engine starts again.

Inspection End.