DTC Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
3. Turn ignition switch ON.
4. Check the voltage between "fuel level sensor unit and fuel pump" harness connector and ground.

   +		-	Voltage (Approx.)
   Fuel level sensor unit and fuel pump
   Connector	Terminal
   B101	8	Ground	5 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between "fuel level sensor unit and fuel pump" harness connector and ECM harness connector.

   Fuel level sensor unit and fuel pump		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   B101	8	E152	180	Existed

4. Also check harness for short to power and short to ground.

Is the inspection result normal?

YES

Perform the trouble diagnosis for ECM power supply circuit. Refer to Diagnosis Procedure .

NO

Repair or replace error-detected parts.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between "fuel level sensor unit and fuel pump" harness connector and ECM harness connector.

   Fuel level sensor unit and fuel pump		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   B101	7	E152	200	Existed

4. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace error-detected parts.

1. Check the continuity between ECM harness connector and ground.

   ECM		--	Continuity
   Connector	Terminal
   F143	3	Ground	Existed
   F142	87
   	88
   E152	199
   	201
   	204

2. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace error-detected parts.

Refer to Component Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace "fuel level sensor unit and fuel pump". Refer to FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY : Removal & Installation .