DTC Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect engine coolant temperature (ECT) sensor 1 harness connector.
3. Turn ignition switch ON.
4. Check the voltage between ECT sensor 1 harness connector and ground.

   +		-	Voltage (Approx.)
   ECT sensor 1
   Connector	Terminal
   F86	1	Ground	5 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between ECT sensor 1 harness connector and ECM harness connector.

   ECT sensor 1		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F86	1	F143	48	Existed

4. Also check harness for short to power and short to ground.

Is the inspection result normal?

YES

Perform trouble diagnosis for ECM power supply circuit. Refer to Diagnosis Procedure .

NO

Repair or replace error-detected parts.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between ECT sensor 1 harness connector and ECM harness connector.

   ECT sensor 1		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   F86	2	F143	29	Existed

4. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace error-detected parts.

1. Check the continuity between ECM harness connector and ground.

   ECM		--	Continuity
   Connector	Terminal
   F143	3	Ground	Existed
   F142	87
   	88
   E152	199
   	201
   	204

2. Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace error-detected parts.

Refer to Component Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace engine coolant temperature sensor 1. Refer to MULTI-WAY CONTROL VALVE : Exploded View .