Common Specs & Procedures
Q60 COMMON SPECS & PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SERVICE DATA | |||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Axle Nut/Hub Nut | ||||
| Front Axle Nut (AWD) | 92 Ft. lbs. (125 N.m) | |||
| Front Hub Bearing Bolts | 65 Ft. lbs. (88.3 N.m) | |||
| Rear Axle Nut | 74-77 Ft. lbs. (100-105 N.m) | |||
| Rear Hub Bearing Bolts | 65 Ft. lbs. (88.3 N.m) | |||
| Battery | SERVICE DATA | |||
| Brakes | ||||
| Bleeding Sequence | BRAKE FLUID : BLEEDING BRAKE SYSTEM | |||
| Disc Brakes | ||||
| Front | FRONT DISC BRAKE | |||
| Rear | REAR DISC BRAKE | |||
| Torque | ||||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Charging | ||||
| Generator | SERVICE DATA | |||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | |||
| Drive Belts | ||||
| Adjustment | Belt tension is adjusted by drive belt auto-tensioner. | |||
| Belt Routing | See Drive Belt Routing in appropriate figure under DRIVE BELT AUTO TENSIONER AND IDLER PULLEY . | |||
| Engine Cooling | ||||
| General Service Specifications | SERVICE DATA | |||
| Radiator Cap Pressure | 18-22 psi (122.3-151.7 kPa (1.2-1.5 kgf/cm2 ) | |||
| Thermostat R & I | MULTI-WAY CONTROL VALVE | |||
| Water Pump R & I | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | GENERAL SPECIFICATIONS | |||
| Oil Pressure | ENGINE OIL PRESSURE : SERVICE DATA | |||
| Overhaul | SERVICE DATA | |||
| Torque | See Torque Specifications in text and applicable figures under DISASSEMBLY AND ASSEMBLY . | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | 65 Ft. lbs. (88 N.m) | |||
| Fuel System | ||||
| Pressure | FUEL PRESSURE RELEASE | |||
| Fuel Pressure Test Procedure | FUEL PRESSURE CHECK | |||
| Fuel Filter Location | Fuel filter is located on fuel pump unit in fuel tank. | |||
| Fuel Filter R & I | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | Engine is equipped with Coil-On-Plug ignition. | |||
| Ignition Wires (Routing) | Engine is equipped with Coil-On-Plug ignition. | |||
| Spark Plugs | NGK - DILKAR8K8G Gap 0.031 in. (0.8 mm) Tightening Torque: 14 Ft. lbs. (19.6 N.m) |
|||
| Starting | ||||
| Starter | SERVICE DATA | |||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Wheel Alignment | ||||
| Adjustment Specifications | ||||
| Front | SERVICE DATA | |||
| Rear | SERVICE DATA | |||
| Torque | ||||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | |||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | |||
| Wheel & Tire | ||||
| Lug Nut Torque | 80 ft. lbs (108 N.m) | |||
| How To Use Nissan Service Information | ||||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | |||