VR30DDTT engine

1. Turn ignition switch OFF.
2. Check ground connection E191. Refer to Ground Inspection in Inspection .

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace ground connection.

1. Disconnect battery current sensor harness connector.
2. Turn ignition switch ON.
3. Check the voltage between battery current sensor harness connector and ground.

   Battery current sensor		Ground	Voltage (V)
   Connector	Terminal
   E7	4	Ground	Approx. 5

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 3.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between battery current sensor harness connector and ECM harness connector.

   Battery current sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   E7	4	F143	42	Existed

Is the inspection result normal?

YES

GO TO 5.

NO

GO TO 4.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the continuity between battery current sensor harness connector and ECM harness connector.

   Battery current sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   E7	2	F143	29	Existed

4. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace error-detected parts.

1. Check the continuity between battery current sensor harness connector and ECM harness connector.

   Battery current sensor		ECM		Continuity
   Connector	Terminal	Connector	Terminal
   E7	1	F143	56	Existed

2. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace error-detected parts.

Refer to Component Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace battery negative cable assembly.