Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2020 >> QX60 Pure, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Around View Monitor System) >> Removal And Installation >> Display Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Remove battery terminal and display control unit after a lapse of 30 seconds or more after turning the ignition switch OFF.
  • Before replacing display control unit, perform "READ CONFIGURATION" to save current vehicle specification. Refer to Description .
  1. Disconnect the negative battery terminal. Refer to Removal and Installation .
  2. Remove cluster lid D. Refer to Removal and Installation .
  3. Remove the display control unit screws, then pull out the display control unit and bracket.
  4. Disconnect harness connector from the display control unit, then remove the display control unit and bracket.
  5. Remove the display control unit brackets screws and the display control unit from the display control unit bracket (if necessary).
scientia non olet · About Mike's Workshop Manuals