Work Support

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

Setting change of each setting functions can be performed.

Work item		Description	Refer to
TEMP SET CORRECT		Setting change of temperature setting trimmer can be performed.	Temperature Setting Trimmer
REC MEMORY SET		Setting change of inlet port memory function (REC) can be performed.	Inlet Port Memory Function (REC)
FRE MEMORY SET		Setting change of inlet port memory function (FRE) can be performed.	Inlet Port Memory Function (FRE)
BLOW SET		In FOOT mode, the air blowing to DEF can change ON/OFF.	Foot Position Setting Trimmer
GAS SENSOR ADJUSTMENT ^*1		Setting change of exhaust gas / outside odor detecting sensor sensitivity adjustment function can be performed.	Exhaust Gas/outside Odor Detecting Sensor Sensitivity Adjustment Function
CLEAN SW SET ^*1		Setting change of auto intake switch interlocking movement change function can be performed.	Auto Intake Switch Interlocking Movement Change Function
TARGET EVAPORATOR TEMP UPPER LIMIT SETTING		Setting change of evaporator target temperature upper limit value can be performed.	Setting of Target Evaporator Temperature Upper Limit Value
AIR INLET CHANGE SETTING ^*2	Prohibition	Intake switch cannot be change during stop/start operation.	Setting of Air Inlet Change Control During Stop/Start Operation
	Permission	Intake switch can be change during stop/start operation.
AIR FLOW REDUCTION SETTING ^*2	Prohibition	Air flow is not reduced during stop/start operation.	Setting of Air Flow Reduction Control During Stop/Start Operation
	Permission	Air flow is reduced during stop/start operation. (Initial setting)

^*1 : With ACCS

^*2 : 2.0L turbo gasoline engine models

NOTE: When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10 V or less, the setting of WORK SUPPORT may be cancelled.