Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2018 >> QX30 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Around View Monitor System) >> Around View Monitor System >> DTC/Circuit Diagnosis >> U1010 Control Unit (Can) >> Sonar Control Unit >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. Turn ignition switch OFF and wait at least 30 seconds.
    3. Turn ignition switch ON and wait at least 2 seconds or more.
    4. Select "Self Diagnostic Result" mode of "SONAR using CONSULT.
    5. Check DTC.

    Is DTC U1010 detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About Mike's Workshop Manuals