DTC Detection Logic
| DTC | CONSULT screen terms | DTC detecting condition | ||
|---|---|---|---|---|
| (Trouble diagnosis content) | [Malfunction type] | |||
| P0513 | 00 | Immobilizer (Incorrect Immobilizer Key) |
NO SUBTYPE INFORMATION | The start enable was not issued. |
| 01 | ELECTRICAL MALFUNCTION | The start enable was not issued. There is a general electrical malfunction. | ||
| 02 | GENERAL ELEC MALFUNCTN | The start enable was not issued. There is a general signal malfunction. | ||
| 03 | FM/PWM ERROR | The start enable was not issued. There is a frequency or pulse width modulation malfunction. | ||
| 04 | SYSTEM INTERNAL MALFUNCTN | The start enable was not issued. There is an internal malfunction. | ||
| 05 | SYSTEM PROGRAMMING ERROR | The start enable was not issued. There is a programming malfunction. | ||
| 06 | ALGORITHM BASED ERROR | The start enable was not issued. There is an algorithm malfunction. | ||
| 07 | MECHANICAL MALFUNCTION | The start enable was not issued. There is a mechanical malfunction. | ||
| 08 | BUS SIGNAL/MESSAGE ERROR | The start enable was not issued. There is a signal malfunction or the message is malfunctioning. | ||
| 09 | COMPONENT MALFUNCTION | The start enable was not issued. There is a component malfunction. | ||
| 10 | - | The start enable was not issued. Reserved for ISO/SAE | ||
| 11 | CIRCUIT SHORT TO GROUND | The start enable was not issued. There is a short circuit to ground. | ||
| 12 | CIRCUIT SHORT TO BATTERY | The start enable was not issued. There is a short circuit to positive. | ||
| 13 | CIRCUIT OPEN | The start enable was not issued. There is an open circuit. | ||
| 14 | CIRC SHORT TO GRND OR OPEN | The start enable was not issued. There is a short circuit to ground or an open circuit. | ||
| 15 | CIRC SHORT TO BATT OR OPEN | The start enable was not issued. There is a short circuit to positive or an open circuit. | ||
| 16 | CIRC VOLT BELOW THRESHOLD | The start enable was not issued. The limit value for electrical voltage has not been attained. | ||