Physical Values

WARNING: This page is about a different variant/trim than selected.

Terminal No. (Wire color)		Description		Condition	Value (Approx.)
+	-	Signal name	Input/Output	Condition	Value (Approx.)
1 (BR)	Ground	AWD solenoid power supply	Output	Engine speed: At idle	0 V
1 (BR)	Ground	AWD solenoid power supply	Output	Engine speed: 3, 000 RPM or more constant	3.1 V^{* 1}
2 (Y)	Ground	AWD solenoid ground	Input	Engine speed: At idle	0 V
2 (Y)	Ground	AWD solenoid ground	Input	Engine speed: 3, 000 RPM or more constant	0 V
3 (W/B)	Ground	Transfer fluid temperature sensor ground	Input	Always	0 V
7 (G)	Ground	Ignition switch	Input	Ignition switch: ON	9 - 16 V
7 (G)	Ground	Ignition switch	Input	Ignition switch: OFF	0 V
8 (L)	-	CAN-H	Input/Output	-	-
9 (BG)	Ground	Power supply (AWD solenoid)	Input	Always	9 - 16 V
10 (B)	Ground	Ground	-	Always	0 V
11 (B)	Ground	Ground	-	Always	0 V
13 (LG)	Ground	Transfer fluid temperature sensor power supply	Output	Transfer temperature: 20°C (68°F)	1.56 V
13 (LG)	Ground	Transfer fluid temperature sensor power supply	Output	Transfer temperature: 80°C (176°F)	0.44 V
15 (W)	Ground	Power supply (AWD control unit)	Input	Always	9 - 16 V
16 (R) ^{* 2} (P) ^{* 3}	-	CAN-L	Input/Output	-	-

*1: The values are changed by depressed accelerator pedal opening and engine speed.

*2: With Gateway.

*3: Without Gateway.

CAUTION:

When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.