Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair battery terminals connection.
- CHECK FUSE
Check for blown fuse and fusible link.
Unit Power Source (Power Supply Terminals) Fuse No. Alternator Battery ("S" terminal) 69 Combination Meter Ignition Switch ON ("L" terminal) 11 Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Be sure to eliminate the cause of malfunction before installing new fuse.
- CHECK "E" TERMINAL CONNECTION
Check if "E" terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair "E" terminal connection.
- CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to INSPECTION .
Is the inspection result normal?
YES
INSPECTION END
NO
Repair as needed.