Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2017 >> Q50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Transfer Case) >> Unit Disassembly And Assembly >> Main Shaft >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2019 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Separate front case and rear case, then remove main shaft assembly. Refer to Disassembly and Assembly .
  2. Remove snap ring SYMBOL from main shaft.
    GNSJPDIE0137Z-137Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove spacer SYMBOL and steel ball SYMBOL from main shaft.
    GNSJPDIE0124Z-124Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to drop the steel ball.
  4. Using a press, remove electric controlled coupling from main shaft.
    GNSJSDIA0818Z-818Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove circlip SYMBOL from notch SYMBOL of electric controlled coupling.
    GNSJSDIA0858Z-858Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Front side
    CAUTION:
    • Never remove the circlip from the electric controlled coupling rear side.
    • Never damage electric control coupling spline, bush, etc.
  6. Remove snap ring from main shaft.
  7. Remove spacer SYMBOL and steel ball SYMBOL from main shaft.
    GNSJSDIA0796Z-796Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to drop the steel ball.
  8. Remove sprocket from main shaft.
  9. Remove needle bearing from main shaft.
  10. Perform inspection after disassembly. Refer to Inspection .
scientia non olet · About Mike's Workshop Manuals