Work Procedure (After Replacement)

WARNING: This page is about a different car, the 2019 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CHECKING SONAR CONTROL UNIT TYPE ID
CONSULT Configuration
1. Perform ECU setting according to the "CONFIGURATION" procedure in the "CONSULT Operation Manual". Refer to CONSULT Operation Manual.
2. Check if the Type ID of the sonar control unit is displayed on the CONSULT screen.
Is Type ID displayed?

YES

GO TO 2 .

NO

GO TO 3 .
WRITING VEHICLE SPECIFICATION
CONSULT Configuration

Follow the procedure displayed in CONSULT for writing the saved vehicle specification data to the sonar control unit.

GO TO 5 .
CHECKING SONAR CONTROL UNIT TYPE ID
Use Global Web-FAST (NISSAN parts catalogue) to search for the sonar control unit of the applicable vehicle and find the Type ID. Refer to "FAST linked" in the "CONSULT Operation Manual".

NOTE: For FAST linked parts, even if a system number cannot be acquired from the sonar control unit before replacement, the applicable ECU setting operation can still be performed by acquiring the system number from Global Web-FAST (NISSAN parts catalogue).

GO TO 4 .
WRITING VEHICLE SPECIFICATION (FAST LINKED)
CONSULT Configuration

Perform ECU setting according to the "C/U setting" procedure in the "CONSULT Operation Manual". Refer to CONSULT Operation Manual.

GO TO 5 .
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
CONSULT Configuration
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON.
4. Check that all ECU self-diagnosis results have no DTC.
WORK END