Blind Spot Warning System Operation Description
WARNING: This page is about a different variant/trim than selected.
- ADAS control unit enables BSW system.
- The ADAS control unit turns on the BSW system when the turned ON by integral switch.
- Side radar detects a vehicle in the adjacent lane, and transmits the vehicle detection signal to ADAS control unit via ITS communication.
- ADAS control unit starts the control as follows, based on a vehicle detection signal, turn signal and dimmer signal transmitted from BCM via CAN communication:
- Blind Spot Warning/Blind Spot Intervention indicator signal and Blind Spot Warning/Blind Spot Intervention indicator dimmer signal transmission to side radar.
- Activates warning buzzer by driver assistance buzzer control module.
- Side radar transmits an indicator operation signal to the Blind Spot Warning/Blind Spot Intervention indicator according to Blind Spot Warning/Blind Spot Intervention indicator signal and Blind Spot Warning/Blind Spot Intervention indicator dimmer signal.
OPERATING CONDITION
- Blind Spot Warning system display (white) : ON (Speaker icon ON in "Blind spot" position)
- Vehicle speed: Approximately 32 km/h (20 MPH) or more.
NOTE:
ON/OFF of Blind Spot Warning system is performed with the integral switch.
- After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 29 km/h (18 MPH)
- The Blind Spot Warning system may not function properly, depending on the situation. Refer to BLIND SPOT WARNING/BLIND SPOT INTERVENTION SYSTEM SERVICE .