Work Procedure (Inspection Mode 6): Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Before using inspection mode 6 (clutch 2 initial set up) when the Li-ion battery level is low, in order to engage clutch 1 and charge the battery from the engine, use CONSULT "EV/HEV""DATA MONITOR" mode and check that the "HV BATTERY LEVEL" reading is 50% or more, or else use the "Li-ion battery state of charge" in the information display on the combination meter and check that the battery level is 50% or more.
- Check that the ATF temperature is 60 °C (140 °F) or more before using inspection mode 6 (clutch 2 initial set up).
- During the work procedure, the engine starts automatically and torque equivalent of creep is generated. Accordingly, the brake pedal must be kept fully depressed throughout the work.