Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2015 >> QX50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Driver Assistance System (ADAS Control Unit) (Introduction) (Hybrid)) >> ADAS Control Unit >> System Description >> Diagnosis System (ADAS Control Unit) >> Consult Function (ICC/ADAS) >> Display Items For The Cause Of Automatic Cancellation 1

Display Items For The Cause Of Automatic Cancellation 1

WARNING: This page is about a different car, the 2015 Infiniti Q70. However, it is still accessible from the selected car via links, so may be relevant.
Cause of cancellation Vehicle-to-vehicle distance control mode Distance Control Assist Forward Emergency Braking Description
OPERATING WIPER *     The wiper operates at HI (it includes when the wiper is operated at HI with the wiper switch AUTO position)
OPERATING ABS * * * ABS function was operated
OPERATING TCS * *   TCS function was operated
OPERATING VDC * * * VDC function was operated
ECM CIRCUIT *     HPCM did not permit ICC operation
OPE SW VOLT CIRC * *   The ICC steering switch input voltage is not within standard range
SNOW MODE SW * *   Shifting of the drive mode selector to SNOW position
OP SW DOUBLE TOUCH *     ICC steering switches were pressed at the same time
VHCL SPD DOWN * *   Vehicle speed lower than 24 km/h (15 MPH)
WHL SPD ELEC NOISE * *   Wheel speed sensor signal caught electromagnetic noise
VDC/TCS OFF SW * * * VDC OFF switch was pressed
VHCL SPD UNMATCH * *   Wheel speed became different from A/T vehicle speed
TIRE SLIP *     Wheel slipped
IGN LOW VOLT * * * Decrease in ADAS control unit ignition voltage
PARKING BRAKE ON *     The parking brake is operating
WHEEL SPD UNMATCH * *   The wheel speeds of 4 wheels are out of the specified values
INCHING LOST *     A vehicle ahead is not detected during the following driving when the vehicle speed is approximately 24 km/h (15 MPH) or less
CAN COMM ERROR * * * ADAS control unit received an abnormal signal with CAN communication
ABS/TCS/VDC CIRC * * * An abnormal condition occurs in VDC/TCS/ABS system
ECD CIRCUIT * * * An abnormal condition occurs in ECD system
ENG SPEED DOWN *     Engine speed became extremely low while controlling ICC system
ASCD VHCL SPD DTAC       Vehicle speed is detached from set vehicle speed
ASCD DOUBLE COMD       Cancel switch and operation switch are detected simultaneously
APA HI TEMP   *   The accelerator pedal actuator integrated motor temperature is high
ICC SENSOR CAN COMM ERR * * * Communication error between ADAS control unit and the ICC sensor
4WD LOCK MODE * * *
NOTE:

The item is displayed, but not used

ABS WARNING LAMP * *   ABS warning lamp ON
FR RADAR BLOCKED * * * Inclusion of dirt or stains on the ICC sensor area of the front bumper
FEB) CURVATURE     * Road curve was more than the specified value
FEB) YAW RATE     * Detected yawing speed was more than the specified value
FEB) LTRL ACCELERATION     * Detected lateral speed is the specified value or more
RADAR INTERFERENCE * * * ICC sensor receives electromagnetic interference
NO RECORD * *   -