Data Monitor
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Item [Unit] | Description | |
|---|---|---|
| IGN VOLT | [V] | Displays the ignition power supply voltage. |
| CONTROL MODULE MALF | [Off/On] | Displays chassis control module malfunction. |
| CAN DIAG STATUS | [Off/On] | Displays CAN network diagnosis status. |
| STP LAMP OFF RELAY 1 | [Off/On] | Displayed but not used. |
| STP LAMP OFF RELAY 2 | [Off/On] | Displayed but not used. |
| ESS RELAY | [Off/On] | Displayed but not used. |
| VEHICLE SPEED | [km/m] | Displays the vehicle speed. |
| FR WHEEL SPEED | [RPM] | Displays the rotational speed of front RH tire. |
| FL WHEEL SPEED | [RPM] | Displays the rotational speed of front LH tire. |
| RR WHEEL SPEED | [RPM] | Displays the rotational speed of rear RH tire. |
| RL WHEEL SPEED | [RPM] | Displays the rotational speed of rear LH tire. |
| STEERING ANG SENSOR | [deg] | Displays the steering angle from the steering angle sensor. |
| DECEL G SENSOR | [G] | Displays the decel G. |
| SIDE G SENSOR | [G] | Displays the side G. |
| YAW RATE SENSOR | [deg/s] | Displays the yaw rate. |
| ACCELE PEDAL POSITION | [%] | Displays the accelerator pedal position. |
| THROTTLE CONTROL | [NORMAL/INCORR/PREV/INPOSSI] | Displays the electric throttle status. |
| SHIFT POSITION | [Off/P/R/N/D (A)/S/L/B/1 - 6/M 1 - M 8/A 1 - A 6] | Displays the shift position. |
| BRAKE SWITCH 2 | [Off/On] | Displays brake switch operating status (Off: close/On: open). |
| BRAKE SWITCH 1 | [Off/On] | Displays brake switch operating status (Off: open/On: close). |
| PRESS SENSOR | [bar] | Displays the brake fluid pressure. |
| ABS | [NORMAL/ABNOR] | Displays ABS function status. |
| ABS MALF | [NORMAL/ABNOR] | Displays ABS function status. |
| EBD | [NORMAL/ABNOR] | Displays EBD function status. |
| ACCELE PEDAL MALF | [NORMAL/ABNOR] | Displays the accelerator pedal status. |
| TCS | [NORMAL/ABNOR] | Displays TCS function status. |
| TCS MALF | [NORMAL/ABNOR] | Displays TCS function status. |
| VDC | [NORMAL/ABNOR] | Displays VDC function status. |
| VDC MALF | [NORMAL/ABNOR] | Displays VDC function status. |
| VDC OFF SWITCH | [Off/On] | Displays VDC OFF switch status. |
| PARKING BRAKE | [Off/On] | Displays the parking brake operating status. |
| DRV TRQ CTRL MODE | [INITIAL/NORMAL/STOP 1/STOP 2/LIMIT 1/PROHIBI] | Displays the status of correction to slightly increase/decrease the drive torque. |
| DRV TRQ CTRL PERMIS 1 | [NO PER/PERMIS] | Displays the permission status (basic requirement) of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL PERMIS 2 | [NO PER/PERMIS] | Displays the permission status (system requirement) of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL STOP | [REQ/NO REQ] | Displays the stop request status of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL PROHIBIT | [REQ/NO REQ] | Displays the prohibition request status of correction to slightly increase/decrease drive torque. |
| DRIVE MODE SELECTOR | [STD/SPORT/SNOW/ECO/PERSO/NOT SET] | Displays the drive mode select switch selection status. |
| LOG-IN PERMIS | [NO PER/PERMIS] | Displays the login authority status of Infiniti InTuition function. |
| I-KEY LINK | [Off/On] | Displays the Intelligent Key linking status of Infiniti InTuition function. |
| USER | [USER A/USER B/USER C/GUEST] | Displays the current user status of Infiniti InTuition function. |
| ENGINE/TM SETTING | [SPORT/STD/ECO/SNOW] | Displays the engine/transmission setting status with Infiniti drive mode selector function. |
| STRG SETTING | [STD/SPT/TOUR/SPT-L] | Displays steering characteristic. |
| ALC SETTING | [Off/LOW/HIGH] | Displays Active Lane Control setting status with Infiniti drive mode selector function. |
| ATC SETTING | [Off/On] | Displays active trace control function setting status with Infiniti drive mode selector function. |
| COMBI METER | [STD/SPORT/SNOW/ECO/PERSO] | Displays the combination meter function setting status with Infiniti drive mode selector function. |
| ATC 1 | [Off/On] | Displays active trace control function operating status. |
| ATC 2 | [Off/On] | Displays active trace control function operating status. |
| ATC 4 | [Off/On] | Displays active trace control function operating status. |
| FL TIRE DISP | [DEF/1] | Displays the status of front LH tire displayed on the information display in the combination meter. |
| FR TIRE DISP | [DEF/1] | Displays the status of front RH tire displayed on the information display in the combination meter. |
| RL TIRE DISP | [DEF/1] | Displays the status of rear LH tire displayed on the information display in the combination meter. |
| RR TIRE DISP | [DEF/1] | Displays the status of rear RH tire displayed on the information display in the combination meter. |
| TURN DISP | [N STEER/LEFT/RIGHT] | Displays the turning direction of active trace control function on the information display in the combination meter. |
| ALC LEVEL | [0 - 4] | Displays active/inactive status of Active Lane Control. |
| ALC STATUS | [INACT/ACT] | Display Active Lane Control operating status. |
| ATC DISP | [Off/On] | Displays the operating status of active trace control function on the information display in the combination meter. |
| ALC DISP | [Off/On] | Displays the operating status of Active Lane Control on the information display in the combination meter. |
| ALC SYSTEM | [Off/On] | Display Active Lane Control activation status. |
| LANE MARKER (LH) | [NOT/DETECT] | Displays the lane marker (LH) detection status. |
| LANE MARKER (RH) | [NOT/DETECT] | Displays the lane marker (RH) detection status. |
| TURN SIGNAL (LH) | [Off/On] | Displays the turn signal switch (LH) operating status. |
| TURN SIGNAL (RH) | [Off/On] | Displays the turn signal switch (RH) operating status. |
| TURN SIGNAL SWITCH | [Off/LEFT/RIGHT/MALF] | Displays the turn signal switch operating status. |
| DAST | [Off/On] | Displays Direct Adaptive Steering operating status. |
| ROAD DISTORTION | [1/m] | Displays the road curvature. |
| COMMAND ST ANG | [rad] | Displays the steering command value to Direct Adaptive Steering. |
| ST PINION ANG | [rad] | Displays the steering pinion angle. |
| ST WHL FORCE TORQUE | [Nm] | Displays the steering wheel force torque. |
| COMMAND ST WHL FORCE | [N] | Displays the reaction force command value to Direct Adaptive Steering. |
| LDW DISP | [On/MALF] | Displays LDW status received from ADAS control unit. |
| LDP DISP | [On/MALF] | Displays LDP status received from ADAS control unit. |
| BSI DISP | [On/MALF] | Displays Blind spot intervention function status received from ADAS control unit. |
| ST SWITCH COND | [OK/NG 1/NG 2] | Displays the steering switch status received from ADAS control unit. |
| BSW COND | [NORMAL/ABNOR] | Displays BSW status received from ADAS control unit. |
| ADAS COND | [NORMAL/ABNOR] | Displays ADAS status received from ADAS control unit. |
| COLLISION WARN | [Off/On] | Displays collision warning status received from ADAS control unit. |
| ICC ACTIVE | [Off/On] | Displays ICC operating status received from ADAS control unit. |
| IBA ACTIVE | [Off/On] | Displays intelligent brake assist operating status received from ADAS control unit. |
| DR BUZZER STATUS | [NO/1/2/3/1, 2/2, 3/1, 3/4] | Displayed but not used. |
| LDW COND | [On/MALF] | Displays LDW status transmitted to ADAS control unit. |
| LDP COND | [On/MALF] | Displays LDP status transmitted to ADAS control unit. |
| BSI COND | [On/MALF] | Displays blind spot intervention function status transmitted to ADAS control unit. |
| LDP BRAKE CANCEL | [NONE/SLIP/SNOW/VDC OF] | Displays LDP cancel cause transmitted to ADAS control unit. |
| BSI BRAKE CANCEL | [NONE/SLIP/SNOW/VDC OF] | Displays blind spot intervention function cancel cause transmitted to ADAS control unit. |
| CAMERA COND | [NORMAL/ABNOR] | Displays the lane camera unit status. |
| CAMERA TEMP COND | [NORMAL/ABNOR] | Displays the lane camera unit status by temperature. |
| CAMERA COMM COND | [NORMAL/ABNOR] | Displays the communication status with the lane camera unit status. |
| CAMERA AIMING | [INCOMP/COMP] | Displays the lane camera unit aiming status. |
| CAMERA HIGH TEMP (LDW) | [NORMAL/ABNOR] | Displays the lane camera unit system cancel request due to high temperature (LDW). |
| CAMERA HIGH TEMP (LDP) | [NORMAL/ABNOR] | Displays the lane camera unit system cancel request due to high temperature (LDP) |
| CAMERA HIGH TEMP (BSI) | [NORMAL/ABNOR] | Displays the lane camera unit system cancel request due to high temperature (Blind spot intervention) |
| SIDE RADAR BLOCK CANCEL | [NORMAL/BLOCK] | Displays the side radar status. |
| BSI LAMP REQ (LH) | [Off/On] | Displays blind spot intervention indicator blink request at blind spot intervention operation (LH). |
| BSI LAMP REQ (RH) | [Off/On] | Displays blind spot intervention indicator blink request at blind spot intervention operation (RH). |
| LANE DEPARTURE DISP (LH) | [NO DISP/DEVIAT] | Displays the deviating status on the LH side lane. |
| LANE DEPARTURE DISP (RH) | [NO DISP/DEVIAT] | Displays the deviating status on the RH side lane. |
| LDP/BSI ACTIVE | [Off/On] | Displays LDP/blind spot intervention function operation status. |
| ADAS COND | [NORMAL/ABNOR] | Displayed, but not used |
| DR BUZZER COND | [NORMAL/ABNOR] | Displayed, but not used |
| OUTSIDE TEMP | [°C] | Displays the ambient temperature. |
| WIPER STATUS | [Off/LOW/HIGH/MALF] | Displays the front wiper operating status. |