Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2013 >> QX56 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Security Control System (Except CROSSCABRIOLET)) >> DTC/Circuit Diagnosis >> DTC B261A: Push-Button Ignition Switch >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECTION START 

    Perform inspection in accordance with procedure that confirms DTC.

    Which procedure confirms DTC? 

    DTC confirmation procedure 1: GO TO 2.

    DTC confirmation procedure 2: GO TO  4.

  2. CHECK PUSH-BUTTON IGNITION SWITCH OUTPUT SIGNAL 1 
    1. Turn ignition switch OFF.
    2. Disconnect push-button ignition switch connector and IPDM E/R connector.
    3. Check voltage between push-button ignition switch harness connector and ground.
      (+) (-) Voltage (V) (Approx.)
      Push-button ignition switch
      Connector Terminal
      M101 4 Ground Battery voltage

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 3.

  3. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 1 
    1. Disconnect BCM connector.
    2. Check continuity between push-button ignition switch harness connector and BCM harness connector.
      Push-button ignition switch BCM Continuity
      Connector Terminal Connector Terminal
      M101 4 M121 60 Existed
    3. Check continuity between push-button ignition switch harness connector and ground.
      Push-button ignition switch Ground Continuity
      Connector Terminal
      M101 4 Not existed

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: Repair or replace harness or connector.

  4. CHECK PUSH-BUTTON IGNITION SWITCH OUTPUT SIGNAL 2 
    1. Turn ignition switch OFF.
    2. Disconnect push-button ignition switch connector and BCM connector.
    3. Check voltage between push-button ignition switch harness connector and ground.
      (+) (-) Voltage (V) (Approx.)
      Push-button ignition switch
      Connector Terminal
      M101 4 Ground Battery voltage

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 2 
    1. Disconnect IPDM E/R connector.
    2. Check continuity between push-button ignition switch harness connector and IPDM E/R harness connector.
      Push-button ignition switch IPDM E/R Continuity
      Connector Terminal Connector Terminal
      M101 4 E10 28 Existed
    3. Check continuity between push-button ignition switch harness connector and ground.
      Push-button ignition switch Ground Continuity
      Connector Terminal
      M101 4 Not existed

      Is the inspection result normal? 

      YES: GO TO 6.

      NO: Repair or replace harness or connector.

  6. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END

scientia non olet · About Mike's Workshop Manuals