Component Inspection

WITH CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Select "DATA MONITOR" mode with CONSULT.
5. Check that the "L/FUEL PRES SEN V" value.

   Data monitor item	Condition	Value (Approx.)
   L/FUEL PRES SEN V	Engine speed: idle	3, 000 - 3, 300 mV
   	Engine speed: 3, 000 rpm (no load)

WITHOUT CONSULT

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Check low fuel pressure sensor signal voltage.

   +		-	Condition	Value (Approx.)
   Low fuel pressure sensor		Ground
   Connector	Terminal
   F39	2	Ground	[Engine is running] Warm-up condition Idle speed	Courtesy of NISSAN NORTH AMERICA, INC.
   			[Engine is running] Warm-up condition Engine speed: 2, 000 rpm	Courtesy of NISSAN NORTH AMERICA, INC.

   Is the inspection result normal? 

   YES: INSPECTION END.

   NO: Replace low fuel pressure sensor. Refer to "EXPLODED VIEW ".