Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2013 >> M56 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1087 To P2542 >> DTC P1564: ICC Steering Switch >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK ICC STEERING SWITCH CIRCUIT 
    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals under the following conditions.
      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      M160 102 (ICC steering switch signal) 111 MAIN switch: Pressed Approx. 0
      DYNAMIC DRIVE ASSISTANCE switch: Pressed Approx. 1.0
      CANCEL switch: Pressed Approx. 1.9
      DISTANCE switch: Pressed Approx. 2.6
      COAST/SET switch: Pressed Approx. 3.2
      ACCELERATE/RESUME switch: Pressed Approx. 3.7
      All ICC steering switches: Released Approx. 4.2

      Is the inspection result normal? 

      YES: GO TO  7.

      NO: GO TO 2.

  2. CHECK ICC STEERING SWITCH GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Disconnect combination switch harness connector.
    4. Check the continuity between combination switch and ECM harness connector.
      Combination switch ECM Continuity
      Connector Terminal Connector Terminal
      M303 16 M160 130 Existed
    5. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART 

    Check the following.

    • Combination switch (spiral cable)
    • Harness for open and short between ECM and combination switch

      : Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK ICC STEERING SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check the continuity between combination switch and ECM harness connector.
      Combination switch ECM Continuity
      Connector Terminal Connector Terminal
      M303 13 M160 128 Existed
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Combination switch (spiral cable)
    • Harness for open and short between ECM and combination switch

      : Repair open circuit, short to ground or short to power in harness or connectors.

  6. CHECK ICC STEERING SWITCH 

    Refer to "COMPONENT INSPECTION (ICC STEERING SWITCH) ".

    Is the inspection result normal? 

    YES: GO TO 7.

    NO: Replace ICC steering switch. Refer to "ENGINE CONTROL SYSTEM: COMPONENT PARTS LOCATION ".

  7. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END

scientia non olet · About Mike's Workshop Manuals