Diagnosis Procedure
- CHECK THROTTLE CONTROL MOTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Disconnect electric throttle control actuator harness connector.
- Disconnect ECM harness connector.
- Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
DTC Electric throttle control actuator ECM Continuity Bank Connector Terminal Connector Terminal P1233 2 F64 5 F111 62 Not existed 58 Existed 6 62 Existed 58 Not existed P2101 1 F66 5 F111 57 Not existed 63 Existed 6 57 Existed 63 Not existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 2.
NO: Repair or replace malfunctioning part.
- CHECK THROTTLE CONTROL MOTOR
Refer to "COMPONENT INSPECTION (ELECTRIC THROTTLE CONTROL MOTOR) ".
Is the inspection result normal?
YES: GO TO 3.
NO: GO TO 4.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: GO TO 4.
NO: Repair or replace harness or connectors.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace malfunctioning electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".
: INSPECTION END