Diagnosis Procedure

1. Turn ignition switch ON.
2. Check voltage between driver side door lock assembly (key cylinder switch) harness connector and ground.

   Terminals			Key position	Voltage (V) (Approx.)
   (+)		(-)
   Driver side door lock assembly (key cylinder switch) connector	Terminal
   D15	6	Ground	Lock	0
   			Neutral/Unlock	5
   	5		Unlock	0
   			Neutral/Lock	5

   Is the inspection result normal? 

   YES: GO TO  6.

   NO: GO TO 2.

Check voltage between power window main switch harness connector and ground.

Is the inspection result normal? 

YES: GO TO 3.

NO: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

1. Turn ignition switch OFF.
2. Disconnect power window main switch connector and driver side door key lock assembly (key cylinder switch) connector.
3. Check continuity between power window main switch harness connector and driver side door lock assembly (key cylinder switch) harness connector.

   Power window main switch connector	Terminal	Driver side door lock assembly (key cylinder switch) connector	Terminal	Continuity
   D8	4	D15	6	Existed
   	6		5

4. Check continuity between power window main switch harness connector and ground.

   Power window main switch connector	Terminal	Ground	Continuity
   D8	4		Not existed
   	6

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

Check continuity between driver side door lock assembly (key cylinder switch) harness connector and ground.

Is the inspection result normal? 

YES: GO TO 5.

NO: Repair or replace harness.

Check door key cylinder switch.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 6.

NO: Replace driver side door lock assembly (key cylinder switch). Refer to "DOOR LOCK: REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END