Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2013 >> FX50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System - DTCS P0222 To P1088) >> DTC P0550: PSP Sensor >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2013 Infiniti FX37. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER STEERING PRESSURE SENSOR 
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Start engine and let it idle.
    4. Check the voltage between ECM harness connector terminals under the following conditions.
      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      F113 87 96 Steering wheel Being turned 0.5 - 4.5
      Not being turned 0.4 - 0.8

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace power steering pressure sensor. Refer to "VQ37VHR: EXPLODED VIEW ".

scientia non olet · About Mike's Workshop Manuals