DTC Confirmation Procedure

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

: GO TO 2.

With CONSULT 

1. Turn ignition switch ON.
2. Select "SLCT LVR POSI" and "MANU MODE SW" in "Data Monitor" in "TRANSMISSION".
3. Maintain the following each conditions more than 60 seconds.

   SLCT LVR POSI: D

   MANU MODE SW: ON

4. Perform "Self Diagnostic Results" in "TRANSMISSION".

   Is "P1815" detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END