Work Procedure
CAUTION:
Be careful of traffic conditions and safety around the vehicle when performing road test.
NOTE:
Fully understand the following items well before the road test;
- Precautions: Refer to "PRECAUTION FOR BSW/BSI SYSTEM SERVICE ".
- System description for BSW: 3 "BLIND SPOT WARNING (BSW) SYSTEM: SYSTEM DESCRIPTION ".
- System description for BSI: 3 "BLIND SPOT INTERVENTION (BSI) SYSTEM: SYSTEM DESCRIPTION ".
- Normal operating condition: Refer to "DESCRIPTION ".
- LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to "INSPECTION PROCEDURE ".
: GO TO 2.
- CHECK BSW SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the navigation screen.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
: GO TO 3.
- BSW SYSTEM ACTION TEST
- Enable the setting of the BSW system on the navigation screen.
- Turn warning systems switch ON (warning systems ON indicator is ON).NOTE: BSI system is OFF.
- Check BSW operation according to the following table.
Vehicle condition/Driver's operation Action Warning systems ON indicator Vehicle speed (Approx.) [km/h (MPH)] Turn signal condition Status of vehicle detection within detection area Indication on the BSW/BSI indicator Buzzer OFF - - - OFF OFF ON Less than approx. 29 (18) - - OFF OFF Approx. 32 (20) or more - Vehicle is absent OFF OFF OFF Vehicle is detected ON OFF ON (Vehicle detected direction) Before turn signal operates Vehicle is detected Blink Short continuous beep Vehicle is detected after turn signal operates Blink OFF NOTE:- If vehicle speed exceeds approximately 32 km/h (20MPH), BSW function operates until the vehicle speed becomes lower than approximately 29km/h (18MPH).
- Time shown in the figure below is approximate time.
- Always BSI system operates together with BSW system. Whenever BSI system is turned on by pushing the dynamic driver assistance switch, BSW system also be turned on even if the BSW system is turned off. However, at this time the warning systems ON indicator remains OFF.
: GO TO 4.
- CHECK BSI SYSTEM SETTING
- Start the engine.
- Check that the BSI system setting can be enabled/disabled on the navigation screen.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
: GO TO 5.
- CHECK DYNAMIC DRIVER ASSISTANCE SWITCH
- Start the engine.
- After starting the engine wait for 5 seconds or more.
- Enable the setting of the BSI system on the navigation screen.
- Press the dynamic driver assistance switch.
- Check that the BSI ON indicator on the combination meter illuminates.
- Check that the BSI ON indicator turns OFF when the system is turned OFF by pressing the dynamic driver assistance switch.
- Check that the BSI ON indicator turns OFF when the engine starts again.NOTE:
- The BSI ON indicator does not illuminate even when the dynamic driver assistance switch is turned ON within approximately 5 seconds after starting the engine.
- When the BSI system setting is disabled on the navigation screen, the BSI ON indicator is not turned ON by pressing the dynamic driver assistance switch.
: INSPECTION END