Inlet Port Memory Function: Description

When ignition switch is turned from OFF to ON, inlet port can be set to AUTO or manual.

Operating procedures for this trimmer are as per the following:

1. Begin self-diagnosis STEP-5 mode. Refer to "DIAGNOSIS DESCRIPTION ".
2. Press fan (UP:+) switch to set system in auxiliary mode.
3. Press intake switch as desired.

   AUTO INTAKE indicator	REC indicator	Setting status		Setting changeover method
   		FRE	REC
   OFF	ON	AUTO control (Initial setting)	Manual REC status is memorized. (Initial setting)	Intake switch: ON
   ON	ON	Manual FRE status is memorized.	Manual REC status is memorized.
   ON	OFF	Manual FRE status is memorized.	AUTO control
   OFF	OFF	AUTO control	AUTO control

   NOTE: When battery cable is disconnected or battery voltage is below 10 V, memory function is canceled. Memory function set becomes that of initial condition.