Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2012 >> FX50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine Control System - DTCS P0441 Through P1168) >> DTC P0550: PSP Sensor >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2012 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER STEERING PRESSURE SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Start engine and let it idle.
    4. Check the voltage between ECM harness connector terminals as per the following conditions:
      ECM Condition Voltage (V)
      Connector + -
      Terminal Terminal
      F102 87 96 Steering wheel Being turned 0.5 - 4.5
      Not being turned 0.4 - 0.8

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace power steering pressure sensor. Refer to "VQ35HR: EXPLODED VIEW ".

scientia non olet · About Mike's Workshop Manuals