Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2012 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Power Control System) >> Power Distribution System >> DTC/Circuit Diagnosis >> DTC B2616: Ignition Relay Circuit >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK IGNITION RELAY
    1. Turn ignition switch OFF.
    2. Remove ignition relay.
    3. Check the continuity between ignition relay terminals.
      CONTINUITY SPECIFICATION

      Terminals Condition Continuity
      3 and 5 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace Ignition relay.

      Fig 1: Checking Continuity Between Relay Terminals 3 And 5
      G04889520Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals