Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2012 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Power Control System) >> IPDM E/R >> Removal And Installation >> IPDM E/R (Intelligent Power Distribution Module Engine Room) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery cable from the negative terminal.
  2. Remove the cowl top cover (RH). Refer to "EXPLODED VIEW ".
  3. Pull up the IPDM E/R assembly while pressing the pawls (A) on the back of the IPDM E/R cover B (1).
    Fig 1: Identifying IPDM E/R Cover B
    G05730931Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove the IPDM E/R cover A (1) while pressing the pawls (A) at the lower end of the IPDM E/R cover A.
  5. Disconnect the harness connector and remove the IPDM E/R (2).
    Fig 2: Location Of IPDM E/R Cover, Pawl And IPDM E/R
    G04889516Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove the bolts (A) and remove the bracket (1) from the vehicle.
    Fig 3: Location Of Bolts And Bracket
    G05975023Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals