DRIVER SIDE : Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW MOTOR (DRIVER SIDE) INPUT SIGNAL

Turn ignition switch OFF.
Disconnect front power window motor (driver side) connector.
Turn ignition switch ON.

Check voltage between power window motor (driver side) harness connector and ground.

VOLTAGE REFERENCE CHART

(+)		(-)	Condition		Voltage (V) (Approx.)
Front power window motor (driver side)
Connector	Terminal
D26	1	Ground	Power window main switch (front LH switch)	NEUTRAL	0
	1			UP	12
	3			NEUTRAL	0
	3			DOWN	12

Is the inspection result normal?

YES: Replace front power window motor (driver side). Refer to , "REMOVAL AND INSTALLATION ".

NO: GO TO 2.

CHECK POWER WINDOW MOTOR CIRCUIT

Turn ignition switch OFF.
Disconnect power window main switch connector.

Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.

CONTINUITY REFERENCE CHART

Power window main switch		Front power window motor (driver side)		Continuity
Connector	Terminal	Connector	Terminal	Continuity
D5	8	D26	1	Existed
D5	11	D26	3	Existed

Check continuity between power window main switch harness connector and ground.

CONTINUITY REFERENCE CHART

Power window main switch		Ground	Continuity
Connector	Terminal
D5	8		Not existed
	11

Is the inspection result normal?

YES: Replace power window main switch. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair or replace harness.