Work Support
WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
WORK SUPPORT ITEMS DESCRIPTION
| Work support items | Description |
|---|---|
| CAUSE OF AUTO-CANCEL | Displays causes of automatic cancellation of the ICC system. |
| LASER BEAM ADJUST | Outputs laser beam, calculates dislocation of the beam, and indicates adjustment direction. |
Display Items For The Cause Of Automatic Cancellation
NOTE:
- Causes of the maximum five cancellations (system cancel) are displayed.
- The displayed cancellation causes display the number of the ignition switch ON/OFF up to 254. It is fixed to 254 if it is over 254. It returns to 0 when the same cancellation cause is detected again.
x: Applicable
OPERATION REFERENCE
| Cause of cancellation | Vehicle-to-vehicle distance control mode | Conventional (fixed speed) cruise control mode | DCA system | Description |
|---|---|---|---|---|
| OPERATING WIPER | x | The wiper operates at HI or LO | ||
| OPERATING ABS | x | x | ABS function was operated | |
| OPERATING TCS | x | x | x | TCS function was operated |
| OPERATING VDC | x | x | x | VDC function was operated |
| ECM CIRCUIT | x | x | ECM did not permit ICC operation | |
| OPE SW VOLT CIRC | x | x | x | The ICC steering switch input voltage is not within standard range |
| LASER SUNBEAM | x | x | Intense light such as sunlight entered ICC sensor integrated unit light sensing part | |
| LASER TEMP | x | x | Temperature around ICC sensor integrated unit became low | |
| OP SW DOUBLE TOUCH | x | x | ICC steering switches were pressed at the same time | |
| WHL SPD ELEC NOISE | x | x | x | Wheel speed sensor signal caught electromagnetic noise |
| VDC/TCS OFF SW | x | x | VDC OFF switch was pressed | |
| SNOW MODE SW | x | x | Snow mode switch was pressed | |
| VHCL SPD UNMATCH | x | x | x | Wheel speed became different from A/T vehicle speed |
| TIRE SLIP | x | x | Wheel slipped | |
| IGN LOW VOLT | x | x | x | Power supply voltage became low |
| WHEEL SPD UNMATCH | x | x | x | The wheel speeds of 4 wheels are out of the specified values |
| VHCL SPD DOWN | x | x | x | Vehicle speed lower than the speed as follows
|
| CAN COMM ERROR | x | x | x | ICC sensor integrated unit received an abnormal signal with CAN communication |
| ABS/TCS/VDC CIRC | x | x | x | An abnormal condition occurs in VDC/TCS/ABS system |
| BCU CIRCUIT | x | x | x | The brake booster control unit is malfunctioning |
| INCHING LOST | x | A vehicle ahead is not detected during the following driving when the vehicle speed is approximately 24 km/h (15 MPH) or less | ||
| ASCD VHCL SPD DTAC | x | Vehicle speed is detached from set vehicle speed | ||
| ASCD DOUBLE COMD | x | Cancel switch and operation switch are detected simultaneously | ||
| PARKING BRAKE ON | x | x | The parking brake is operating | |
| APA HI TEMP | x | The accelerator pedal actuator integrated motor temperature is high | ||
| NO RECORD | x | x | x | - |
Laser Beam Adjust
Refer to "LASER BEAM AIMING ADJUSTMENT : DESCRIPTION ".