Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2012 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Engine Control System - DTCS P1217 To P2A03) >> P1564 ASCD Steering Switch >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Turn ignition switch ON and wait at least 10 seconds.
    2. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
    3. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
    4. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
    5. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
    6. Check DTC.

    Is DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals