Removal and Installation: Installation
WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
Note the following, and install in the reverse order of removal.
CAUTION:
- Be careful not to damage connector when installing any connector.
- Do not reuse drain plug gasket.
- Do not reuse O-ring.
- Apply ATF to O-ring.
- Adjust bolt hole of bracket to bolt hole of control valve with TCM when installing A/T fluid temperature sensor 2 (with bracket).
- Refer to the followings when installing control valve with TCM in transmission case.CAUTION:
- Make sure that turbine revolution sensor securely installs turbine revolution sensor hole (B).
- Hang down revolution sensor harness toward outside so as not to disturb installation of control valve with TCM.
- Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
- Assemble it so that manual valve (1) cutout is engaged with manual plate (2) projection.
- Install bolts (A), (B) and (C) in control valve with TCM. Tighten bolt 1, 2 and 3 temporarily to prevent dislocation. After that tighten them in order (1 → 2 → 3), and then tighten other bolts. Tighten control valve with TCM bolts to the specified torque.
BOLT SYMBOL CHART
| Bolt symbol | A | B | C |
|---|---|---|---|
| Number of bolts | 5 | 6 | 1 |
| Length mm (in) | 42 (1.65) | 55 (2.17) | 40 (1.57) |
| Tightening torque N.m (km-g, in-lb) | 7.9 (0.81, 70) | With ATF applied | |
| 7.9 (0.81, 70) | |||
- Refer to the followings when installing oil pan (2) (with oil pan gasket) and clips (1) to transmission case.
CAUTION:
- Do not reuse oil pan gasket and oil pan mounting bolts.
- Install oil pan gasket in the direction to align hole position.
- Install it so that drain plug (3) comes to the position as shown in the figure.
- Be careful not to pinch harnesses.
- Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.
- Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten oil pan mounting bolts to the specified torque.