Component Inspection (Electric Throttle Control Motor)

1. Turn ignition switch OFF.
2. Disconnect electric throttle control actuator harness connector.
3. Check resistance between electric throttle control actuator terminals as per the following.
   RESISTANCE SPECIFICATION
   
   

   Terminals	Resistance
   5 and 6	Approx. 1 - 15 Ω [at 25°C (77°F)]

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

INSPECTION END