Component Inspection (Fuel Rail Pressure Sensor)

WITH CONSULT-III

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Select "DATA MONITOR" mode with CONSULT-III.
5. Check that the "FUEL PRES SEN V" indication.
   MONITOR ITEM CONDITION
   
   

   Monitor Item	Condition	Values/Status
   FUEL PRES SEN V	Engine speed: Idle	980 - 1, 200 mV
   	Engine speed: Revving engine from idle to 4, 000 RPM quickly	1, 100 - 2, 900 mV

WITHOUT CONSULT-III

1. Turn ignition switch OFF.
2. Reconnect harness connector disconnected.
3. Start the engine.
4. Check FRP sensor signal voltage.
   VOLTAGE SPECIFICATION
   
   

   +		-		Condition	Value (Approx.)
   ECM
   Connector	Terminal	Connector	Terminal
   F111	31	F111	40	[Engine is running] Warm-up condition Idle speed	0.98 - 1.2 V
   				[Engine is running] Warm-up condition Revving engine from idle to 4, 000 RPM quickly	1.1 - 2.9 V

   Is the inspection result normal? 

   YES: INSPECTION END.

   NO: Replace FRP sensor. Refer to "EXPLODED VIEW ".