Sleep mode activation
WARNING: This page is about a different variant/trim than selected.
- BCM receives the sleep-ready signal (ready) from IPDM E/R and unified meter and A/C amp. via CAN communication.
- BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
- Each unit stops the transmission of CAN communication with the sleep wake up signal. BCM is in CAN communication sleep mode.
- BCM is in the low power consumption mode and perform the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.
Sleep condition
SLEEP CONDITION CHART
| CAN sleep condition |
BCM sleep condition |
- Receiving the sleep-ready signal (ready) from all units
- Ignition switch: OFF
- Vehicle security system and panic alarm: Not operation
- Warning chime: Not operation
- Intelligent Key system buzzer: Not operation
- Trunk room lamp switch status: No change
- Stop lamp switch: OFF
- ICC brake hold relay (with ICC): OFF
- Key slot (card switch) status: No change
- Turn signal indicator lamp: Not operation
- Exterior lamp: OFF
- Door lock status: No change
- CONSULT-III communication status: Not communication
- Meter display signal: Non-transmission
- Door switch status: No change
- Rear window defogger: OFF
|
- Interior room lamp battery saver: Time out
- Power window switch and retractable hard top control unit communication: No transmission
- Push-button ignition switch illumination: OFF
- Infiniti Vehicle Immobilizer System (IVIS) - NATS: Not operation
- Remote keyless entry receiver communication status: No communication
- Tire pressure monitor system (TPMS) - AIR PRESSURE MONITOR: Stop
- LOCK indicator lamp: OFF
- ACC indicator lamp: OFF
- ON indicator lamp: OFF
|