ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement

1. PERFORM ECM RECOMMUNICATING FUNCTION
   1. Install ECM.
   2. Insert the registered Intelligent Key* into key slot, turn ignition switch to "ON".

      *: To perform this step, use the key that is used before performing ECM replacement.

   3. Maintain ignition switch in the "ON" position for 5 seconds or more.
   4. Turn ignition switch to "OFF".
   5. Start engine.

Can engine be started? 

YES: Procedure is complete.

NO: Initialize control unit. Refer to CONSULT-III Operation Instructions NATS-IVIS/NVIS.