Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2011 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (Engine Control System - DTC U0164 Through P0181) >> DTC U1003: Can Comm Circuit >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2010 Infiniti G37. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 10 V at idle. 

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Turn ignition switch ON and wait at least 3 seconds.
    2. Check DTC.

      Is DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals