| FR LH SENSOR [km/h (MPH)] |
x |
x |
Wheel speed |
| FR RH SENSOR [km/h (MPH)] |
x |
x |
| RR LH SENSOR [km/h (MPH)] |
x |
x |
| RR RH SENSOR [km/h (MPH)] |
x |
x |
| STOP LAMP SW (On/Off) |
x |
x |
Stop lamp switch signal status |
| BATTERY VOLT (V) |
x |
x |
Battery voltage supplied to the ABS actuator and electric unit (control unit) |
| GEAR |
x |
x |
Gear position determined by TCM |
| SLCT LVR POSI |
x |
x |
A/T selector lever position |
| YAW RATE SEN (d/s) |
x |
x |
Yaw rate detected by yaw rate/side G sensor |
| ACCEL POS SIG (%) |
x |
↓ |
Throttle actuator opening/closing is displayed (Linked with accelerator pedal) |
| SIDE G-SENSOR (m/s2
) |
x |
↓ |
Transverse G detected by yaw rate/side G sensor |
| STR ANGLE SIG (°) |
x |
↓ |
Steering angle detected by steering angle sensor |
| PRESS SENSOR (bar) |
x |
↓ |
Brake fluid pressure detected by pressure sensor |
| ENGINE RPM [tr/min (RPM)] |
x |
↓ |
Engine speed |
| FLUID LEV SW (On/Off) |
x |
↓ |
Brake fluid level switch signal status |
| PARK BRAKE SW (On/Off) |
x |
↓ |
Parking brake switch signal status |
| LDP) APP SEN (%) |
x |
x |
Accelerator pedal position sensor status received from ECM via CAN communication |
| FR RH IN SOL (On/Off) |
↓ |
x |
Operation status of each solenoid valve |
| FR RH OUT SOL (On/Off) |
↓ |
x |
| FR LH IN SOL (On/Off) |
↓ |
x |
| FR LH OUT SOL (On/Off) |
↓ |
x |
| RR RH IN SOL (On/Off) |
↓ |
x |
| RR RH OUT SOL (On/Off) |
↓ |
x |
| RR LH IN SOL (On/Off) |
↓ |
x |
| RR LH OUT SOL (On/Off) |
↓ |
x |
| MOTOR RELAY (On/Off) |
↓ |
x |
Motor and motor relay operation |
| ACTUATOR RLY (On/Off) |
↓ |
x |
Actuator relay operation |
| ABS WARN LAMP (On/Off) |
↓ |
x |
ABS warning lamp |
| OFF LAMP (On/Off) |
↓ |
x |
VDC OFF indicator lamp |
| SLIP/VDC (On/Off) |
↓ |
x |
VDC warning lamp |
| EBD SIGNAL (On/Off) |
↓ |
↓ |
EBD operation |
| ABS SIGNAL (On/Off) |
↓ |
↓ |
ABS operation |
| TCS SIGNAL (On/Off) |
↓ |
↓ |
TCS operation |
| VDC SIGNAL (On/Off) |
↓ |
↓ |
VDC operation |
| EBD FAIL SIG (On/Off) |
↓ |
↓ |
EBD fail-safe signal |
| ABS FAIL SIG (On/Off) |
↓ |
↓ |
ABS fail-safe signal |
| TCS FAIL SIG (On/Off) |
↓ |
↓ |
TCS fail-safe signal |
| VDC FAIL SIG (On/Off) |
↓ |
↓ |
VDC fail-safe signal |
| CRANKING SIG (On/Off) |
↓ |
↓ |
Crank operation |
| USV[FR-RL] (On/Off) |
↓ |
↓ |
VDC switch-over valve |
| USV[FL-RR] (On/Off) |
↓ |
↓ |
| HSV[FR-RL] (On/Off) |
↓ |
↓ |
| HSV[FL-RR] (On/Off) |
↓ |
↓ |
| V/R OUTPUT (On/Off) |
↓ |
↓ |
Solenoid valve relay activated |
| M/R OUTPUT (On/Off) |
↓ |
↓ |
Actuator motor and motor relay activated |
| LDP) APP SEN (%) |
x |
x |
Accelerator pedal position sensor status received from ECM via CAN communication |
| LDP) ICC MAIN SW (On/Off) |
x |
x |
ICC MAIN switch status received from ECM via CAN communication |
| LDP) LDP ON SW (On/Off) |
x |
x |
Dynamic driver assistance switch status received from ECM via CAN communication |
| LDP) WIPER SIGNAL (Stop/PRTCT/1low/1high/Low/High) |
x |
x |
Front wiper operating condition received from BCM via CAN communication |
| LDP) BRAKE SW (On/Off) |
x |
x |
Brake switch signal status |
| LDP) STOP LMP SW (On/Off) |
x |
x |
Stop lamp switch signal status |
| LDP) LDW SW (On/Off) |
x |
x |
Warning systems switch status received from lane camera unit via CAN communication |
| LDP) SHIFT POSITION (OFF/P/R/N/D/MM 1st - MM 5th) |
x |
x |
Shift position received from TCM via CAN communication |
| LDP) TURN SIGNAL (Off/LH/RH/LH&RH) |
x |
x |
Turn signal operating condition received from BCM via CAN communication |