DTC Confirmation Procedure

1. PRECONDITIONING

   If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

   GO TO 2.

2. CHECK DTC DETECTION

With CONSULT 

1. Start the engine.
2. Run engine for at least 2 consecutive seconds at idle speed.
3. Perform "Self Diagnostic Results" in "TRANSMISSION".

With GST 

Follow the procedure "With CONSULT"

Is "U1000" detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END