Component Inspection (Manual Mode Switch)
Check continuity between A/T shift selector connector terminals.
CONTINUITY SPECIFICATION
| A/T shift selector connector | Condition | Continuity | |
|---|---|---|---|
| Terminal | |||
| 1 | 4 | Selector lever is shifted to manual shift gate side | Existed |
| Other than the above | Not existed | ||
| 2 | Selector lever is shifted to - side | Existed | |
| Other than the above | Not existed | ||
| 3 | Selector lever is shifted to + side | Existed | |
| Other than the above | Not existed | ||
| 5 | Selector lever is shifted to manual shift gate side | Not existed | |
| Other than the above | Existed | ||
Is the inspection result normal?
YES: INSPECTION END
NO: Repair or replace damaged parts. Refer to "REMOVAL AND INSTALLATION ".