Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transaxle >> DTC/Circuit Diagnosis >> DTC P0720: Output Speed Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

CAUTION:
  • Always drive vehicle at a safe speed.
  • Be careful not to rev engine into the red zone on the tachometer.
  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. CHECK DTC DETECTION

With CONSULT 

  1. Start the engine.
  2. Select "ESTM VSP SIG" in "Data Monitor" in "TRANSMISSION".
  3. Drive vehicle and maintain the following conditions for 60 seconds or more.

    ESTM VSP SIG : 40 km/h (25 MPH) or more

  4. Perform "Self Diagnostic Results" in "TRANSMISSION".

    With GST 

    Follow the procedure "With CONSULT".

    Is "P0720" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals