DTC Confirmation Procedure

1. PRECONDITIONING

   If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

   GO TO 2.

2. CHECK DTC DETECTION

With CONSULT 

1. Start the engine.
2. Select "SLCT LVR POSI", "GEAR", "VHCL/S SE-A/T", "CLSD THL POS" and "ENGINE SPEED" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
   CAUTION: Keep the same gear position.
   NOTE: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.

   SLCT LVR POSI : D

   GEAR : 2nd, 3rd, 4th, 5th or 6th

   VHCL/S SE-A/T : More than 40 km/h (25 MPH)

   CLSD THL POS : OFF

   ENGINE SPEED : More than 1,500 rpm

4. Perform "Self Diagnostic Results" in "TRANSMISSION".

   With GST 

   Follow the procedure "With CONSULT".

   Is "P0717" detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END