Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TRUNK KEY CYLINDER SWITCH INPUT SIGNAL

Turn ignition switch OFF.
Disconnect trunk key cylinder switch connector.

Measure voltage between trunk key cylinder switch harness connector and ground.

VOLTAGE REFERENCE CHART

(+)		(-)	Voltage (Approx.)
Trunk key cylinder switch
Connector	Terminal
T11	1	Ground	12 V

Is the inspection result normal?

YES: GO TO 4.

NO: GO TO 2.

CHECK TRUNK KEY CYLINDER SWITCH SIGNAL CIRCUIT

Disconnect BCM connector.

Measure continuity between BCM harness connector and trunk key cylinder switch harness connector.

CONTINUITY REFERENCE CHART

BCM		Trunk key cylinder switch		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M121	49	T11	1	Existed

Measure continuity between BCM harness connector and ground.

CONTINUITY REFERENCE CHART

BCM		Ground	Continuity
Connector	Terminal
M121	49		Not existed

Is the inspection result normal?

YES: GO TO 3.

NO: Repair or replace harness.

REPLACE BCM
1. Replace BCM. Refer to , "REMOVAL AND INSTALLATION ".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.
  INSPECTION END

CHECK TRUNK KEY CYLINDER SWITCH GROUND CIRCUIT

Measure continuity between trunk key cylinder switch harness connector and ground.

CONTINUITY REFERENCE CHART

Trunk key cylinder switch		Ground	Continuity
Connector	Terminal
T11	2		Existed

Is the inspection result normal?

YES: GO TO 5.

NO: Repair or replace harness.

CHECK TRUNK KEY CYLINDER SWITCH
Refer to "COMPONENT INSPECTION ".

Is the inspection result normal?

YES: GO TO 6.

NO: Replace trunk key cylinder switch.
CHECK INTERMITTENT INCIDENT
Refer to , "INTERMITTENT INCIDENT ".

INSPECTION END