Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Power Control System (CROSSCABRIOLET)) >> Power Distribution System >> DTC/Circuit Diagnosis >> DTC B2616: Ignition Relay Circuit >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK IGNITION RELAY POWER SUPPLY-1
    1. Turn ignition switch OFF.
    2. Remove ignition relay.
    3. Check voltage between ignition relay harness connector and ground.
      VOLTAGE REFERENCE CHART

      (+) (-) Condition Voltage (V) (Approx.)
      Ignition relay
      Terminal
      1 Ground Ignition switch OFF or ACC 0
      ON Battery voltage

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 2.

  2. CHECK IGNITION RELAY POWER SUPPLY-2
    1. Disconnect fuse block (J/B) connector.
    2. Check voltage between fuse block (J/B) harness connector and ground.
      VOLTAGE REFERENCE CHART

      (+) (-) Condition Voltage (V) (Approx.)
      Fuse block (J/B)
      Connector Terminal
      M3 6C Ground Ignition switch OFF or ACC 0
      ON Battery voltage

      Is the inspection result normal? 

      YES: Replace fuse block (J/B).

      NO: GO TO 3.

  3. CHECK IGNITION RELAY POWER SUPPLY CIRCUIT-1
    1. Disconnect BCM connector.
    2. Check continuity between fuse block (J/B) harness connector and BCM harness connector.
      CONTINUITY REFERENCE CHART

      Fuse block (J/B) BCM Continuity
      Connector Terminal Connector Terminal
      M3 6C M122 82 Existed
    3. Check continuity between fuse block (J/B) harness connector and ground.
      CONTINUITY REFERENCE CHART

      Fuse block (J/B) Ground Continuity
      Connector Terminal
      M3 6C Not existed

      Is the inspection result normal? 

      YES: Replace BCM. Refer to , "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

  4. CHECK IGNITION RELAY GROUND CIRCUIT

    Check continuity between ignition relay harness connector and ground.

    CONTINUITY REFERENCE CHART

    Ignition relay Ground Continuity
    Terminal
    2 Existed

    Is the inspection result normal? 

    YES: GO TO 5.

    NO: Repair ignition relay ground circuit.

  5. CHECK IGNITION RELAY POWER SUPPLY CIRCUIT-2
    1. Install ignition relay.
    2. Turn ignition switch ON.
    3. Check voltage between ignition relay harness connector and ground.
      VOLTAGE REFERENCE CHART

      (+) (-) Voltage (V) (Approx.)
      Ignition relay
      Terminal
      5 Ground Battery voltage

      Is the inspection result normal? 

      YES: GO TO  7.

      NO: GO TO 6.

  6. CHECK IGNITION RELAY

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Replace fuse block (J/B).

    NO: Replace ignition relay.

  7. CHECK INTERMITTENT INCIDENT

    Refer to , "INTERMITTENT INCIDENT ".

    INSPECTION END

scientia non olet · About Mike's Workshop Manuals