Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Power Control System (CROSSCABRIOLET)) >> Power Distribution System >> DTC/Circuit Diagnosis >> DTC B2614: Acc Relay >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ACCESSORY RELAY
    1. Turn ignition switch OFF.
    2. Remove accessory relay.
    3. Check the continuity between accessory relay terminals.
      CONTINUITY REFERENCE CHART

      Terminals Condition Continuity
      3 and 5 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace accessory relay.

      Fig 1: Identifying Relay Terminals
      G04889520Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals